(texinfo.gz) Using Info-validate

(texinfo.gz) Running Info-Validate
 
 Running `Info-validate'
 -----------------------
 
   To use `Info-validate', visit the Info file you wish to check and
 type:
 
      M-x Info-validate
 
 Note that the `Info-validate' command requires an upper case `I'.  You
 may also need to create a tag table before running `Info-validate'.
  Tagifying.
 
   If your file is valid, you will receive a message that says "File
 appears valid".  However, if you have a pointer that does not point to
 a node, error messages will be displayed in a buffer called `*problems
 in info file*'.
 
   For example, `Info-validate' was run on a test file that contained
 only the first node of this manual.  One of the messages said:
 
      In node "Overview", invalid Next: Texinfo Mode
 
 This meant that the node called `Overview' had a `Next' pointer that
 did not point to anything (which was true in this case, since the test
 file had only one node in it).
 
   Now suppose we add a node named `Texinfo Mode' to our test case but
 we do not specify a `Previous' for this node.  Then we will get the
 following error message:
 
      In node "Texinfo Mode", should have Previous: Overview
 
 This is because every `Next' pointer should be matched by a `Previous'
 (in the node where the `Next' points) which points back.
 
   `Info-validate' also checks that all menu entries and cross references
 point to actual nodes.
 
   `Info-validate' requires a tag table and does not work with files
 that have been split.  (The `texinfo-format-buffer' command
 automatically splits large files.)  In order to use `Info-validate' on
 a large file, you must run `texinfo-format-buffer' with an argument so
 that it does not split the Info file; and you must create a tag table
 for the unsplit file.
Info Catalog
(texinfo.gz) Running Info-Validate
(texinfo.gz) Unsplit
automatically generated byinfo2html